Cisco Certified Network Associate (CCNA)

Course Overview

CCNA in broadly Cisco Certified Network Associate is an entry level certification for the Cisco certified professional training program. This course improves the performance of junior network administrators. CCNA Routing and Switching knowledge is required for Network Administrators, Network Specialists and Network Support Engineers. The CCNA Routing and Switching authorize the ability to install, configure, operate, and troubleshoot medium size routed and switched networks. We teach a very professional training on CCNA and the syllabus we follow written in bellow

Course Duration: 3 Months Total Class: 28 Class
Class Duration: 2 Hours Class Start: Class Start:
Course Fee: 9,000 Taka

Course Outline

CCNA 1 – Introduction to Networks
  • Network basic
  • Network models– OSI Model– TCP/IP Model
  • Ethernet Technology
  • IP Addressing
    – Subnetting IP Networks
    – VLSM
  • Cisco IOS overview
  • Configuring a Network Operating System
CCNA 2 – Routing Essentials
  • Routing Concepts
  • Static Routing
  • Routing Dynamically
  • Routing Information Protocol ( RIP)
  • Enhance Interior Gateway Routing Protocol (EIGRP)
  • Open Shortest Path First (OSPF)
    – Single Area OSPF
    – Multiarea OSPF
  • Access Control List
  • Dynamic Host Configuration Protocol(DHCP)
CCNA 3 – Switching Essentials and Scaling Networks
  • Basic Switching Concepts and Configuration
  • VLANs
  • Inter-VLAN Routing
  • Spanning Tree Protocol (STP)
  • Rapid Spanning Tree Protocol (RSTP)
  • Per-VLAN Spanning Tree (PVST)
  • LAN Redundancy
    – Hot Standby Router Protocol (HSRP)
    – Virtual Router Redundancy Protocol (VRRP)
    – Gateway Load Balancing Protocol (GLBP)
  • Link Aggregation
  • Wireless Networks
CCNA 4 – Connecting Networks
  • Hierarchical Network Design
  • Connecting to the WAN
  • Network Address Translation (NAT)
  • Point to Point connection
  • Frame Relay
  • Troubleshooting the Network
  • IPv6

Lab 1 : Logging into a Router & Introduce with cisco IOS and its features

Lab 2 : Basic Router configuration and configuring line console, Telnet, SSH

Lab 3 : Configuration back up & restoring the configuration and password recovery

Lab 4 : IOS up gradation by USB, TFTP and IOS up gradation in Rommon mode

Lab 5 : Configuring and verifying Static route and RIP

Lab 6 : Configuring and verifying EIGRP

Lab 7 : Configuring and verifying OSPF

Lab 8 : Basic Switch configurations

Lab 9 : Configuring VLANs, Trunk Ports and Inter-VLAN Routing

Lab 10: Configuring Dynamic Host Configuration Protocol

Lab11 : Configuring HSRP, VRRP, GLBP

Lab 12: Configuring Access List

Lab 13: Configuring Network Address Translation

Lab14 : Configuring Wireless Devices

Lab 15: Configuring Point – to – Point Connection

Lab 16: Configuring Frame relay


*** All labs will be done with Cisco Packet Tracer as well as using real Cisco Routers, Switches and Access points

Facebook Auto Publish Powered By :